Thermal design of a finned double pipe heat exchanger for methanol cooling
DOI:
https://doi.org/10.5377/nexo.v34i02.11549Keywords:
Pressure drop, Thermal Design, Hairpins, Heat Exchanger, Pumping PowerAbstract
In the present work, the thermal design of a double tube heat exchanger with finned tubes for methanol cooling was performed. Two sensitivity studies were also carried out to determine the influence of an increase in both the feed rate (mc) and the methanol inlet temperature (T1) on four exchanger design parameters. The designed heat exchanger will have a fin efficiency of 0.236, a cleaning factor of 0.60, a heat transfer area under fouling conditions of 20.53 m2, and a total number of hairpins equal to three to meet the thermal duty of the system. Both the calculated pressure drop of the cooling water (5,880.39 Pa) and the methanol (70,711.91 Pa) are below the maximum limits established by the process. A pumping power of 17.52 W and 160.62 W is required to pump the cooling water and methanol respectively. It is recommended that mc does not exceed 5,800 kg/h, while T1 can be increased up to 80 ºC without negatively affecting the pressure drop of the cooling water, although this increases the pumping power of the cooling water.Caída de presión
Downloads
1061
Downloads
Published
How to Cite
Issue
Section
License
The authors who publish in Nexo Scientific Journal agree to the following terms:
- Authors retain the copyright and grant the journal the right of the first publication under the license Creative Commons Attribution License, which allows others to share the work with a recognition of the authorship of the work and the initial publication in Nexo Scientific Journal.
- Authors may separately establish additional agreements for the non-exclusive distribution of the version of the work published in the journal (for example, in an institutional repository or a book), with the recognition of the initial publication in Nexo Scientific Journal.
- Authors are allowed and encouraged to disseminate their works electronically (for example, in institutional repositories or in their own website) before and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published works.